Fisher Labs 1280-X Manual do Utilizador descarregar pdf (Página 22)

MAINTENANCE

CLEANING

Hose down your 1280-X with clean fresh water whenever you’ve

had it on the beach or in the water. Pay particular attention to the

following areas:

1. Stem adapter. Sand or dirt between the coil “ears”

and stem adapter will literally grind away the ears

and adapter.

2. Headphone. The ear pads may be removed, rinsed

and squeezed out to remove any seawater salt build

up. Rinse out the cups to keep the vent holes clear.

NOTE: These vent holes MUST be kept clear when

diving to equalize ear pressure.

3. Between the upper and lower stems. Sand, silt or

fine dirt will cause the lower stem to freeze up.

4. Control Panel. Rinse the area under the three knobs

thoroughly.

5. Battery Cover. Always clean and dry the area

around the battery cover seal before opening.

BATTERY COMPARTMENT

1. Remove the battery cover and check for water after

each use in water.

2. Keep the sealing surfaces of the battery cover and

control housing clean and free of scratches and nicks.

Remove and clean the neoprene gasket frequently.

Lubricating the gasket is not recommended. Cleaning

the gasket should only be done by using mild soap

and warm water. Do not use petroleum jelly or silicone

grease at any time.

STORAGE

Remove the batteries from the battery pack when storing your

1280-X for extended periods to prevent damage caused by battery

leakage.

Never leave your 1280-X in an auto trunk or even in a closed

passenger compartment during hot weather. Temperatures in excess

of 120°F are possible which could damage electronic components

and ruin the batteries.

1 2 ... 17 18 19 20 21 22 23 24 25 26

Sem comentários

Fisher Labs 1280-X Manual do Utilizador Página 22